1. | ![]() |
성형 및 금형 개요 1 | 과목 개요, 성형 및 금형 개요 | ![]() |
![]() |
성형 및 금형 개요 2 | ![]() |
||
2. | ![]() |
금형 재료 | 금형 재료 | ![]() |
3. | ![]() |
금형 제작 기술 | 금형 제작 기술 | ![]() |
4. | ![]() |
플라스틱 사출성형 1 | 1. 사출성형 2. 플라스틱 재료 3. 제품 설계와 공정조건 | ![]() |
![]() |
플라스틱 사출성형 2 | ![]() |
||
![]() |
플라스틱 사출성형 3 | ![]() |
||
5. | ![]() |
사출금형 설계 1 | 1. 금형 구조 2. 강도 설계 3. 러너와 게이트 4. 취출시스템 5. 언더컷 6. 냉각시스템 7. 벤팅 | ![]() |
![]() |
사출금형 설계 2 | Study to provide a structural design for the mold that will notbreak due to fatigue across many molding cycles, and excessively deflect under load | ![]() |
|
![]() |
사출금형 설계 3 | Study about kinds of runner and gate which are part of mold design | ![]() |
|
![]() |
사출금형 설계 4 | Study about Ejection requirement and factors to be taken into account | ![]() |
|
![]() |
사출금형 설계 5 | Study about Undercut Mold Design | ![]() |
|
![]() |
사출금형 설계 6 | Study that a mold is a highly stressed heat exchanger and thecooling phase of the injection molding cycle isextremely important | ![]() |
|
![]() |
사출금형 설계 7 | Study about venting which is air which remains in the cavity during the filling state | ![]() |
|
6. | ![]() |
박판성형 1 | 1. 박판성형 2. 소성학 | ![]() |
![]() |
박판성형 2 | Study about Plasticity's definition and graph | ![]() |
|
7. | ![]() |
프레스 다이 1 | 1. 다이 개요 2. 블랭킹 다이 설계 | ![]() |
![]() |
프레스 다이 2 | Study about press die design(blanking and punching dies) | ![]() |